2001 Polaris SLX, PRO 1200, Virage TX, Genesis, Virage TXi, Genesis i Personal Watercraft Service Manual, Page 327Get this manual

2001 Polaris SLX, PRO 1200, Virage TX, Genesis, Virage TXi, Genesis i Personal Watercraft Service Manual, Page 327

Fuel Injection System Action StepsFuel System Step 5: Voltage Supply TestsBattery must be of adequate capacity, fully charged
(PN 287 frO(ii fear of EMM and conneel.rFI Service Power Con connected to stop switchengine not running 20 voltsCheck WhiteRed
than 24 volts and steady at idl$ wire anCf'!lJ(oundvolts and supply voltage at injectorGo i" the leads of monitored using
,ttStEtD at the blue (29), purpl ), an 9) wires of the pin outOKrepair wire or replace engine wiring harnessInspect connector
at injection and wire harness No voltage on all Check voltage at pin connector and 7No voltage on and 7, check Ohm test on
stator windingsIf OK, replace the EMM Conclusion The fuel system should now operate properlyIf some cylinders are still running