2002 Polaris Freedom, Virage, Genesis PWC Service Manual, Page 66Get this manual

2002 Polaris Freedom, Virage, Genesis PWC Service Manual, Page 66

Maintenance HullControl SystemsContinued Adjustment ProcedureContinued 5Use main cable adjuster nuts to make major adjustmentsAdjuster
Cable Adjustment The reverse cable does not require periodic adjustmentIf the reverse linkage does not function properly,
inspect the cable for damageInspect all linkage, fasteners, brackets, and pivots for wear or damageWhen new cable is installed
the cable must be adjusted1Place reverse shift lever in reverse position2Loosen cable adjuster nuts3Adjust cable until reverse
gate locating collars engage fully into reverse actuator locating slot when slight upward pressure is applied to reverse
gateReverse gate must float in the notch and should not be forced in4Check gate locking by pulling up on gate when in down
position5Move shift lever to forward positionReverse gate must be above water stream6Tighten adjuster nuts securely7Seal