2002 Polaris Freedom, Virage, Genesis PWC Service Manual, Page 202Get this manual

2002 Polaris Freedom, Virage, Genesis PWC Service Manual, Page 202

Final DrivePropulsion Drive Shaft Inspection 1Clean driveshaft and support inblocks as shown (C)Measure runout by rotating
end playReplace if worn, cracked or damagedNOTE: If drive shaft, impeller, or coupler splines are worn or damaged, improper
pump-to-hull, or pump-toengine alignment should be suspectedRefer to Pump Drive shaft Alignment on pages 5.12 5.14 for more
informationDrive Shaft End Play .100-.200 (2.54-5.08mm) Stator Disassembly 1Remove tail cone screws (3) and tail coneInspect
Oring seal located behind tail coneReplace seal if damage is evidentNOTE: When removing tail cone, hold stator with cone
pointed downTwist cone offThis will allow any water from entering the impeller assemblyIt is normal for small amount of water