2003 Polaris Freedom, Virage and Genesis PWC Service Manual, Page 42Get this manual

2003 Polaris Freedom, Virage and Genesis PWC Service Manual, Page 42

Maintenance Water Injection Solenoid MaintenanceVirage i Inspect and clean the water injection solenoid at 25 hour intervals
apart, make certain you do not loose any partsDO NOT remove the rubber gasket from the plunger4Inspect the "IN" and "OUT"
ports on the square valve, the plunger assembly, spring, and solenoid barrelClean the components thoroughly by removing any
debris such as sand, algae, weeds, etc5Reassemble the componentsVerify threads are cleanFirmly tighten the solenoid to square
valve to 2030 in.lbs or until white lines are aligned with each other6Re-attach the hose to the pipe fitting and reconnect
the wire harness7Tighten the gear clamp to 22 inlbs Solenoid Plunger Assembly (One side is marked "IN" and one side is marked