2003 Polaris Freedom, Virage and Genesis PWC Service Manual, Page 237Get this manual

2003 Polaris Freedom, Virage and Genesis PWC Service Manual, Page 237

Electrical Systems Dynamic Ignition Timing AdjustmentCarbureted ModelsContinued 12Point timing light at inspection holeBe
screws securely4Verify proper ignition timing with the timing light Ignition Timing AdjustmentIgnition Point Adjustment Unit
1Set timing as indicated in previous section2Access the CDI controller located inside the electrical box3Connect the Ignition
Point Adjustment Unit, PN 2872290 to the data port on the CDI controller4Verify ALL electrical box electrical connection
are completeRemove the timing cover plug5Connect timing light to the MAG high tension leadStart the engineCAUTION: Never
operate engine for more than 15 seconds without cooling waterSevere engine damage may occur from overheating6Timing can be
adjusted with the toolPress either the POS of NEG buttons to either advance or retard ignition timingPressing the POS or
NEG buttons will advance or retard the timing in one degree increments up to degrees each way7After timing is correct, remove