2003 Polaris MSX 140 Personal Watercraft Service Manual, Page 70Get this manual

2003 Polaris MSX 140 Personal Watercraft Service Manual, Page 70

EngineCooling W120HO- DFI Engine Inspection Crankshaft Truing Lubricate the bearings and clamp the crankshaft securely in
strike the shaft at point with brass hammerHIGH .004 (.1mm) HIGH .004 (.1mm) A B NOTE: The rod pin position in relation to
the dial indicator position tells you what action is required to straighten the shaft3To correct situation like the one shown
in the illustration at right, squeeze the crankshaft at point A(Use tool from alignment kit)SUPPORT CRANKSHAFT AT THESE TWO
BEARINGS HIGH .002 (.05mm) HIGH .005 (.13mm) 4If the crank rod pin location is 180_ from the dial indicator (opposite that
shown above), it will be necessary to spread the crankshaft at the position as shown in the illustration at rightWhen rebuilding