2004 Polaris Freedom, Virage, Genesis and MSX-140 Service Manual., Page 168Get this manual

2004 Polaris Freedom, Virage, Genesis and MSX-140 Service Manual., Page 168

FUELEXHAUST SYSTEMS FICHT Troubleshooting"ENGINE TURNS- OVER, BUT WILL NOT START" - Install lanyard in stop switch With lanyard
pressing start button Starter Motor Voltage Drop Test Ignition Coils Use DIt software to test coil functionsDisconnect injector
from harnessDoes engine start? If not, stator, EMM, injector(s), andor harness at fault(NA on Virage models Battery charge
will affect vAC readingsCharge battery to 12.5vDCReplace stator if ANY pins show continuity to groundTo test, obtain known,
good EMMConnect and 12-pin harnesses from boat to this EMMAttempt to start engineCheck ALL EMM ground pins in harness and
engine blockbatteryFuel pressure20 to 30 psiA failed sensor may not show code, or illuminate CHK ENG lampUse DIt software
to view sensor dataReference sensor data using DIt softwareENGINE SYNC should read "TRUE" when pushing start buttonALTERNATOR
VOLTAGE should "step-up" to approximately 22 vDCWhen MAG piston is at TDC, encoder ribs should be visable through the CPS