2004 Polaris Freedom, Virage, Genesis and MSX-140 Service Manual., Page 200Get this manual

2004 Polaris Freedom, Virage, Genesis and MSX-140 Service Manual., Page 200

PROPULSION Impeller Clearance 1Remove lanyard cord and lock plate from engine stop switchDisconnect battery ground () cable2Remove
at point (B)Replace if runout exceeds the service limitNOTE: Excessive driveshaft runout can cause vibration, bearing, and
spline failureSee PumpFinal Drive Troubleshooting at the end of chapter 2Drive Shaft Runout Service Limit: .005 (.13mm) Place
dial indicator at (B) Support in V-blocks at (C) C 2Inspect driveshaft splines and splines inside engine drive coupler and
impeller carefully for wear or damageReplace worn partsRubber bumpers control driveshaft end playReplace if worn, cracked
or damagedNOTE: If drive shaft, impeller, or coupler splines are worn or damaged, improper pump-to-hull, or pump-toengine