2004 Polaris Freedom, Virage, Genesis and MSX-140 Service Manual., Page 212Get this manual

2004 Polaris Freedom, Virage, Genesis and MSX-140 Service Manual., Page 212

PROPULSION REASSEMBLY PROCEDUREAll Models 1Remove engine mounting nuts that were tightened to verify engine alignmentApply
Loctitet 262 (Illustration 4) 8(MSX 140) Install thrust washer over front of HULL LINE driveshaft after it has passed through
the bearing carrier(The beveled side MUST fit flush with DRIVESHAFT BEARING driveshaft bevel (Illustration 5) CARRIER 9(MSX
140) Guide the front of the driveshaft into the drive coupler endHave an assistant insert and screw driveshaft into the drive
coupler from the rear of the boatKeep the beveled end of the thrust washer flush GASKET with the beveled end of the driveshaft
as the shaft is being screwed into the coupler(Illustration 5) THRUST WASHER 10(MSX 140) Once driveshaft is screwed into
coupler, push the bearing carrier back against the pump wallDo not install the mounting screws at this time11If the impeller
was removed from the pump stator, the assembly will have to be rebuilt with new seals, and orings12Reassemble the pump sections