2004 Polaris Freedom, Virage, Genesis and MSX-140 Service Manual., Page 234Get this manual

2004 Polaris Freedom, Virage, Genesis and MSX-140 Service Manual., Page 234

HULL and BODY Steering Cable RemovalInstallation WARNING: Failure to properly install the steering cable can result in loss
an adjustablelocking wrench to remove the thruhull nutWARNING: Due to the location of the uppersteering linkage and bracket,
the shroud assembly, handlebar assembly, and topdeck plug must be removed in order to properly remove and install the steering
cable 7To remove shroud assembly, loosen the four mounting bolts, compartment door mounting plate bolts, and the handlebar
assemblyDetach the MFI harness and the pitot hose at the back of the MFIRemove the access plug from the topdeck8With the
access hole open, loosen and remove the jam nuts that secure the steering cable to the topdeck9Turn the steering column to
the leftLoosen and remove the columntosteering cable mounting bolt10Working from the front of the watercraft to the back,
push the steering cable through the rear thruhull openingContinue working the cable out of the watercraft so that the jam