2004 Polaris Freedom, Virage, Genesis and MSX-140 Service Manual., Page 241Get this manual

2004 Polaris Freedom, Virage, Genesis and MSX-140 Service Manual., Page 241

HULL and BODY Steering Cable InstallationMSX 140 1Insert the new cable through the rear thruhull fitting from the back of
flat towards thruhull nut faceTighten nut to 28 ft.lbs(39 Nm) 6Lightly grease the upper steering linkage7Thread steering
cable into adjusting nutLoosely fit adjusting nut bracket onto steering column base8Install steering cable rodend on top
side of steering arm clampUsing new Nylok nut, torque nut to ft.lbs (11 Nm)9Follow steering cable alignment procedures on
page 6.2710When finished, verify adjusting nut clamp fasteners are torqued to ft.lbs(11 Nm) 2004 CarburetedDIt PWC Service