2004 Polaris Freedom, Virage, Genesis and MSX-140 Service Manual., Page 243Get this manual

2004 Polaris Freedom, Virage, Genesis and MSX-140 Service Manual., Page 243

HULL and BODY Top DeckHull Repair The hull and top deck are manufactured using Fiberglass Reinforced Compound (FRC)Repair
soften the adhesiveProlonged heating will permanently damage the hull2With the footwell pad removed, apply Goo Gonet and
remove all old adhesive from the hullIf scraping is required, only use soft plastic material3Remove Goo Gonet with mild detergent
soapWipe surface with acetoneAllow Acetone to completely dry Footpad Application 4Peel small portion of backing material
away from the new footwell pad, and immediately apply to deck5Work the pad with your fingertips until the entire pad is pressed
onto the deck surfaceConstant pressure activates the adhesive and works out any air bubbles out from under the pad6Allow
for 24 hours for adhesive to cureNOTE: Do not allow the pad temperature to exceed 80 F, or below 60 for at least 24 hoursAlways