2004 Polaris Freedom, Virage, Genesis and MSX-140 Service Manual., Page 255Get this manual

2004 Polaris Freedom, Virage, Genesis and MSX-140 Service Manual., Page 255

ELECTRICAL SYSTEMS MSX 140 RPM Limiter System Diagram MSX GAUGE TANOR TAN PKBLK 13 24 36 GRYRED BLK REVERSE SWITCH (CLOSED
is closed(Located on reverse handle gear assembly Engine coolant temperature is determined to be too hotInternal EMM temperature
is determined to be too hot MSX 140 Reverse Switch Testing 1Insert lanyard into STOP switchStart engine and move the reverse
handle to the full reverse positionEngine RPM should be limited to approximately 3500 RPMIf not, turn engine off and proceed
to step 22Locate switch harness(Switch is fastened to reverse gear assembly and can be accessed through front compartment
door Disconnect switch3Using multimeter set for continuity checks, insert probes into the switchside harnessMove reverse
lever to reverse positionContinuity should be foundIf not, replace the switch and go back to step 1If switch is functioning,
proceed with step 44With the harness still disconnected, insert one probe into BLK pin and the other to engine groundIf no
continuity is found, repair ground circuitInsert one probe into the GRYRED pin and the other into pin 36 located on the 40