2004 Polaris Freedom, Virage, Genesis and MSX-140 Service Manual., Page 261Get this manual

2004 Polaris Freedom, Virage, Genesis and MSX-140 Service Manual., Page 261

ELECTRICAL SYSTEMS Electrical Testing Charging System TestingUnregulated VoltageFreedomVirage 1Open electrical box to gain
voltage is low, check all connections and charge the battery prior to retestNOTE: The regulatorrectifier is located within
the LR moduleIt is not serviceable and must be replaced if suspect StartStop Switch Testing FreedomVirageVirageGenesis 1Set
multimeter to ohms position2Unplug start button harnessConnect multimeter leads to switch harnessPress start switchThe reading
should be .3 ohms or lessA high resistance reading or O.Lreading indicates faulty switch3Release the start buttonAn O.Lreading
should be observedIf low resistance is measured, replace the switchLANYARD SWITCH Lanyard Switch Testing 1Set multimeter
to ohms2Unplug stop switch harness connectorConnect one of the multimeter probes to the BLKY pin, the other to the BLK pinPull
the lanyard from the switchThe reading should be .3 ohms or less3Connect the lanyardAn O.Lreading should be indicatedIf not,
replace the switchSTARTSTOP SWITCH STARTSTOP BUTTON Bilge Switch Testing FreedomVirageVirageGenesis 1Set multimeter to ohmsDisconnect