2004 Poalaris MSX110, MSX150 PWC Original Service Manual, Page 24Get this manual

2004 Poalaris MSX110, MSX150 PWC Original Service Manual, Page 24

MAINTENANCE Steering Cable Adjustment 1Open front compartment doorLoosen and remove adjuster blockAlign handlebars with centerline
not require adjustmentIf the reverse linkage does not function properly, inspect the cable for damageInspect all linkage,
fasteners, brackets, and pivots for wear or damageWhen new cable is installed the cable must be adjusted1Place reverse shift
lever in reverse position2Loosen cable adjuster nuts3Verify that the gate is in its full down position and locked4Check gate
locking by pulling up on gate when in down position5Move shift lever to forward positionReverse gate must be well above the
water stream6Tighten adjuster nuts securely7Seal the cable threads and adjuster nuts with marine grade silicone sealant (PN
8560054) and tighten securelyAllow sealant to cure fully before operating craft Reverse Cable Nut 2004 Four Stroke PWC Service