2004 Poalaris MSX110, MSX150 PWC Original Service Manual, Page 183Get this manual

2004 Poalaris MSX110, MSX150 PWC Original Service Manual, Page 183

PROPULSION Stator Assembly NOTE: Seals, bearings, and o-rings should be replaced if removedHeat the impeller housing evenly
lips up and visible (toward impeller)Press seals to bottom of chamfer on seal bore (about 18 .32 cm beyond end of bore)WARNING:
Never allow the impeller spacer to push up through the two seals when inserting the stub shaftIf spacer pushes though seals,
the seal lips will be compromised and allow water into bearing housing 4Grease and install two new O-rings on stub shaftMount
stub shaft flats in viseGrasp stator assembly with thumbs over impeller spacerCarefully lower assembly over stub shaftVerify
that stub shaft has not pushed impeller spacer up through sealsNOTE: If impeller spacer has pushed up through seals, push
into place slowly and carefully to prevent dislodging seal springs5Hand thread impeller onto stub shaftTorque to specificationsRotate