Bombardier SeaDoo 1989 factory shop manual, Page 24Get this manual

Bombardier SeaDoo 1989 factory shop manual, Page 24

Section 03 ENGINE Sub-section 02 (RiEMOVALINSTALLATION) COMPONENTS ? Hexdqonal nut M8 i4i Lock washer M8 (41 Tuned pipe rtng
bottom of tuned pipe and engine water inlet socketinsert screwdriver through opening between tuned pipe, cylinder and magneto
housing Slacken gear clamp on tuned pipe outlet "TOP END"servicnng nor "MAGNETOFLYWHEEL" However engine removal is necessary
to repair "BOTTOM END" and "ROTARY VALVE" REMOVAL FROM WATERCRAFT In order to remove engine from watercraft proceed as follows
Propulsion System Withdraw jet pump unit ass'y, refer to "PROPULSIONDRIVE SYSTEMS", section 08 CoolingExhaulst Systems NOTETo
release clamp from cooling hoseifuel line, insert screwdriver blade under the end of clamp Pry end out of locking hooks FOOT
017 hose gear clamp Remove tuned pipe mounting nuts, slightly lift it to release nuts as necessary Withdraw tuned pipe in
forward and rotating movement Be careful not to drop 0-rngs located in exhaust manifold grooves Disconnect hose on exhaust