Bombardier SeaDoo 1989 factory shop manual, Page 26Get this manual

Bombardier SeaDoo 1989 factory shop manual, Page 26

Section 03 ENGINE Sub-section 02 (REMOVALINSTALLATION) Carry on engine lifting until engine support reaches body aperture
242 (blue) (PIN 293 800 002) on threads then torque nuts in criss-cross sequence to 35 Nmrn (26 Ibfftt Rotary Valve Supply
Line Make sure to re-install line before completely llower engine in bilge 15,16, ShimRubber Mount Do not remove engine rubber
mounts needlessly They sit on shims which control engineljet pump alignment Alignment has been set at factory and can not
be performed in workshop Always remove rubber mounts one llocation at time and re-install each shim to its orginal NOTEFor
fuel line clamping, use special pliers (PIN 295 000 0701 32,36, Loctite 242Screw Apply Loctite 242 on screw threads and torque
to 25 Nm Ibfft) Electrical Connectiions First, install red positive cable on starter post, then black negative cable on starter
mounting bolt, torque to 22 Nmm (16 lbfaft) Apply Dielectric Grease (PIN 293 550 004) on connectors then cover with boot
Install cable coming from ignition housing, into electrical box cover Connect wires making sure to match wire colors CAUTIONIf