Bombardier SeaDoo 1989 factory shop manual, Page 51Get this manual

Bombardier SeaDoo 1989 factory shop manual, Page 51

Section 03 ENGINE Sub-section (BOTTOM END) Install bearings so that their peripherical grooves be located as shown in following
crankcase halves, apply light coat of Loctite 515 Gasket Eliminator293 800 007) on mating surfaces Do not apply in excess
as it will spread out inside crankcalse NOTEOn aluminum material it is recommended to use Loctite Primer293 600 012) to increase
curing time and gap filling capability Refer to manufacturer's instructions CAUTIONRotary valve shaft must be installed in
crankcase before closing halvesBefore joining crankcase halves, make slure that crankshaft gear its well engaged with rotary
valve shaft gearPosition crankcase halves together and hand-tighten bolts CAUTIONTemporarily install armature plate align
crankcase halves with each other 3,4,5, Screw Apply Loctite 242 (blue) (PIN 293 0021 on screw threads Torque crankcase screws
to 22 Nm (16 Ibf-ft) as per following illustrated sequence engine support or ignition housing See Doo 1989 Shop Manual http:www.ReadManm