Bombardier SeaDoo 1989 factory shop manual, Page 86Get this manual

Bombardier SeaDoo 1989 factory shop manual, Page 86

Section 07 ELECTRICAL Sub-section 02 (IIGNITION TIMING) Timing light pick-up or11 MAG snli Flywheel mark 2 Connect an induction-type
occurence is still before top dead center 4 Check if flywheel mark (or reference one previously scribed) aligns with ignition
housing mark CAUTIONIf engine is be ruin more than few minutes, connect flush kit (PIN 295 0381 properily cooll engineIf
timing marks align, timing is correct Clhecking Igniition Timing NOTETo perform this procedure it is recomiimended to use
stroboscopic timing light rated to work up to 6000 RPM To check ignition timing, use timing light NOTEThis timing light is
battery powered (two batteries, type "C") and therefore needs no auxiliary power source The ignition components are affected
by temperature variation, therefore, timing must be checked when engine scold, after MAXIMUM 20 seconds idling Connect timing