Bombardier SeaDoo 1989 factory shop manual, Page 92Get this manual

Bombardier SeaDoo 1989 factory shop manual, Page 92

Section 07 ELECTRICAL Su b-Section 03 (ELECTRIC STARTER) REMOVAL Unfasten electrical box from hull Disconnect black cable
assembly Pull housing from armature clutch housing to ease further assembly Trace indexing marks here CAUTIONYoke ass'y and
drive unit assembly must not be immersed in cleaning solventDliscard all O-rings and gasket Clean brushes and holders with
clean cloth soaked in solvent Brushes must be dried thoroughly with clean cloth Blow brush holders clean using compressed
air Remove starter support nuts then through bolts Separate end frame from yoke Withdraw yoke from armature Brush holder
can be removed from end frame by unscrewing nut retaining terminal Check that the radial play between the armature shaft
and end frame is not greater than 20008 in) Replace end frame if so WARNINGAlways wear safety goggles when using compressed
air Remove dirt, oil or grease from commutator using clean cloth soaked in suitable solvent Dry well using clean, dry cloth