Bombardier SeaDoo 1989 factory shop manual, Page 97Get this manual

Bombardier SeaDoo 1989 factory shop manual, Page 97

Section 07 ELECTRICAL Sub-Section 04 (MAGNETO SYSTEM) COMPONENTS 7 T7 12 13 14 15 16 77 18 19 20 21 22 23 24 25 26 27 28
Locine 271, 10mL Combined screw M4 Cable clamp Splice connector Shrink tube 30 mm 161 Protection mat Proiecrion cover Screw
taptile MS 12 (21 Holding strip Screw tapttte M4 (2) Cable grommet Sensor wire with plug assembly Grommet Shcone 732 RTV90
Harness (wttfiout connector) Armature plate assembly Woodruff key Grommet Htgfit tension cable set Ring terminalFemale connector
96 (41 Male connector 96 (41 Insulation sbeafh Insulation sheath Locme 515primer N REMOVAL Refer to "ENGINE" under "FLYWHEELMAGNETO",
section 02-04 for parts removal CAUTIONProtect harness from flame$1 - Remove screws - Cut the four wires as close as possible
to the coil DISASSEMBLY 24, Generating Coil To replace generating coil- - To pass new coil wires in harness, tape the old
wires to the end of new wires and pull them through the harness protector tube Heat the armature plate to 150 (300F around