Bombardier SeaDoo 1989 factory shop manual, Page 103Get this manual

Bombardier SeaDoo 1989 factory shop manual, Page 103

Section 07 Sub-section ELECTRICAL 05 (CDICHARGING SYSTEMS) Measure resistance between BLACK and BROWN wires Note resistance
performing some test, allow it to idle while observing indicator Then, shut engine off 5 After every test that lights the
indicator lamp, reset theindicator circuit by depressing the reset button Use of Bornbalrdier Ignition Testelr This tester
can verify generating coil high speed), ignition module, ignition coil and battery charging coil Always make sure that tester
ba,tteries are in good condition Analysis of Test Results Indicator lamp lights at specific setting Output is as specified
Test results should repeat three times If readings do not repeat, output is erratic and cause shoulld be investigated (loose
connections or components, etc Indicator lamp lights at lower setting Test Condition All tests are performed on watercraft
at cranking speed with spark plugs installedAlways proceed in the following order1 Connect tester and clip leads as indicated
for each specific test This indicates that the output is less than that designed to operate in satisfactory manner However,