Bombardier SeaDoo 1989 factory shop manual, Page 116Get this manual

Bombardier SeaDoo 1989 factory shop manual, Page 116

Section 08 PROPULSIONDRIVE SYSTEMS Sub-section 01 (PROPULSIONDRIVE SYSTEMS) Ride shoe screws Grate screws Evenmly tighten
be damageableUse special tool when ride shoe needs to be removed without damage- Use two steel angle bars 25 25 mrn (1 118
in) thick 225 rnrn (9in) long- kind of turnbuckle is needed to apply extension force between ride shoe and hullUse 25 mrn
(1 n! square tube by approximately 125 rnrn I5 in1 long so that, with all parts welded, its overall length will not exceed
190 rnrn (7-112 in)On one end, weld mrn (31in) dianutWeld the head of 10 100 mrn (318 in) screw on top of one angle bar then
screw in square tube- Insert 10 15 mm (318 12 in) screw through large and thick washer or suitable sleeve- Install nut on