Bombardier SeaDoo 1989 factory shop manual, Page 123Get this manual

Bombardier SeaDoo 1989 factory shop manual, Page 123

Sectlion 08 PROPULSIONDRIVE SYSTEMS Sub-section 01& DRIVE SYSTEMS) T install ring in housing, use square steel plate approx
making sure it is equalllly inserted all around Place wood piece over ring Using hammer, strike on wood to push ring Strike
one side then rotate wood piece about 90' and strike againWork this way, frequently rotating wood piece so that ring slides
equally all around until it seats into bottom of housing Protrusion Carefully inspect seal lipsMake sure that lips are not
worn, distorted, cracked or present any other damage Renew as necessary ASSEMBLY 28, Wear Ring If wear ring features lip
on one edge, position lip outwards of housing To ease insertion into housmg, apply liquid soap onto outside circumference