Bombardier SeaDoo 1990 factory shop manual, Page 23Get this manual

Bombardier SeaDoo 1990 factory shop manual, Page 23

Section 03 ENGINE Sulb-Section 01-ENlGINE) WATER-1FLOODED EINGINE If engine is water-flooded, it must be serviced within
againOtherwise serious internal parts damage will occurCheck fuel and oil reservoirs for water contaminationIf necessary,
siphon and refill with fresh fluidsTurn fuel valve to "OFF" bowlposition then drain fuel filter Drain bilge if water is presentRemove
engine crankcase dralin plugs located underneath oil injection pumpWARNINGVentilate billge at least minutes prior checking
spark After engine has started, spray SEA-DO0 lube through carburetor intake while engine is runningRun engine until it reaches
its operational temperatureMake sure to supply water to cool engineCAUTIONWater must be supplied cool engine with flush kit
(PIN 295 000 038)Do not run engine for more than five minutes since drive line seal has no cooling when out of waterDrain
plugs F001 003 008 With spark plugs in place, crank engine to drain crankcaseReinstall crankcase drain plugs CAUTIONCrankcase
drain plugs should have Loctite PST 567 (PIN 293 800 013)applied threads before installingRemove spark plugs and dry them