Bombardier SeaDoo 1990 factory shop manual, Page 26Get this manual

Bombardier SeaDoo 1990 factory shop manual, Page 26

Section 03 ENGINE Sub-section 02 (REMOVALINSTALLATION) Disconnect hose on exhaust manifoldRemove fasteners taking care not
intake silencer boot on carburetor sidePivot intake silencer to rear of watercraft Remove both retaining screws of carburetor
support from engine coverInstall hose pincer on rotary valve oil return line (on top of rotary valve housing) then disconnectRemove
throttle cable from oil injection pump Remove engine support mount screws NOTEBe careful when removing engine support mount
screws, shims could have been installed between engine support and rubber mounts Turn fuel valve to "OFF" position Disconnect
fuel supply linefrom carburetorRemove screw of banjo fitting from fuel return line Be carefull not to drop any partDisconnect
throttle and choke cables from carburetorUnscrew carburetor support from flame arrester coverUnscrew carburetor mount nuts
then remove carburetor and flame arrester togetherslightly lift it to release nuts as necessaryDisconnect impulse line To