Bombardier SeaDoo 1990 factory shop manual, Page 27Get this manual

Bombardier SeaDoo 1990 factory shop manual, Page 27

Section 03 ENGINE Sub-Sectilon 02 (REMOVALINSTALLATION) Engine can be easily llifted using the following suggested tool -
pincer on hose then disconnect Do not remove engine rubber mounts needlesslyThey sit on shims which control engineljet pump
alignmentAlignment has been set at factory and can not be performed in workshopAlways remove rubber mounts one at time and
re-install each shim to its original location- 4ose pincer nstalled FOCI 003 011 Carry on engine lifting until engine support
reaches body aperture then lean engine so that it can completely leave watercraft CAUTIONIf shims different thickness are
interchanged, engine and jet pump will1 be disalignedNOTEIf shims location have been mixed up Contact your area service representative