Bombardier SeaDoo 1990 factory shop manual, Page 28Get this manual

Bombardier SeaDoo 1990 factory shop manual, Page 28

CLEANING Wipe off any spilllage in bilge Clean with bilge cleanerDiscard all gaskets and 0-nngis Clean external parts of
from topPosition saddle so that its higher side is at bottom Install screws paying attention to their different length with
washers as shown- CAUTIONStrict adherence this torqlue is important avoid damaging threads of aluminum insert in bilge 19,21,
Engline Support& Nut Properly install support on crankcase so that rounded portion of support matches with MAG side of crankcase
Apply Loctite 242 (blue) (PIN 293 800 015) on threads torque nuts in criss-cross sequence to 35(26 Ibfmftl Rotary Vallve
Supply Line Make sure to re-install line before completely lower engine in bilge NOTEFor fuel line clamping, use special
pliers (PIN 295 000 070) 32,36,Loctite 242Screw Apply Loctite 242 on screw threads and torque to 25 Nm (18 lbfaft)Electrical
Connections First, install red positive cable on starter post and torque nut to NmimIbfin) then black negative cable on starter
mounting bolt apply Loctite 271 on threads torque to 22 Nm (16 lbfft) Apply lDielectric Grease (PIN 293 550 004) on connectors