Bombardier SeaDoo 1990 factory shop manual, Page 46Get this manual

Bombardier SeaDoo 1990 factory shop manual, Page 46

Section 03 ENGINE Sub-section 04 (FLYWHEELMAGNETO) From now on, these marks will be used for further assembly positioning
section 07-03 for procedures Unscrew retaining screws then withdraw housing 30,35,MAG FlywheelNut Apply Loctite 242 (blue!
293 800 002) on crankshaft taper Position Woodruff key, MAG flywheel, apply Loctite 242 (blue) and install fasteners on crankshaft
Torque nut to 105(77 Ibfft) CAUITIONNever use any type of impact wrench at flywheel1 installlation Clean all metal components
in solvent Clean crankshaft taper and threads CAUTIONClean arrnatuire coils and magneto rnaglnets using only clean cloth
27, PTO Flywheel Apply Loctite 767 Anti-Seize 293 550 001) on crankshaft threads then screw flywheelUsing same tool as for
removal, torque flywheel 110 to Nm (81 lbfeft) CAUTIONNever ulse any type of impact wrench at flywheel installation INSTALLATION
Installation is essentially the reverse of removal procedures However pay particular attention to the following 8,19, Ignition