Bombardier SeaDoo 1990 factory shop manual, Page 63Get this manual

Bombardier SeaDoo 1990 factory shop manual, Page 63

Sub-Section 06' Section 03 ENGINE (ROTARY VALVERESERVOIR) To install rotary valve shaft in crankcase, use Pusher (PIN 2901
method is required Take note that the second method is more accurate and may be used any time Push shaft until it stops For
both methods TDC Gauge (PN 295 000 065) is required Installation on Same Crankcase (with ridge) At snap rmg installation,
position it so that its sharp edge faces outwards To correctly install rotary valve, proceed as follows- 1.2Waiter Inlet
SocketScrew When installing socket, position it so that its nipple is pointing towards ignition housing Turning crankshaft,