Bombardier SeaDoo 1990 factory shop manual, Page 77Get this manual

Bombardier SeaDoo 1990 factory shop manual, Page 77

Section 05 FUEL SYSTEM Sub-section 01 (CARBURETORINTAKE SYSTEM) Flame Arrester WARNINGNlever operate watercraft without flame
lf they come from seat gasket, bubbles will exit around seat Re-tighten as necessary CAUTIONMake sure engine is turned off
before adjusting throttle cableLubricate cable with SEA-DO0 LUBEThrottle lever must reach handlebar grip without causing
strain to cable or carburetor cable bracket If bubbles come from needte, replace needle and seat 61,62,63, Diaphragm, GasketCover
Install diaphragm on carburetor then gasket Properly locate their pilot holes with carburetor pinsMake sure that their small
tongues are inserted into carburetor notch 24,42, O-ring When installing 0-rngs low-speed mixture screw and of main jet,
apply some SEA-DO0 LUBE (PIN 293 600 006) to prevent sticking Must touch handlebar glrip Hose Clamps Properly tighten clamps
with special pliers (PIN 295 000 070) Insure carburetor butterfly is fulllly open at full throttle positionAt thlis position