Bombardier SeaDoo 1990 factory shop manual, Page 83Get this manual

Bombardier SeaDoo 1990 factory shop manual, Page 83

Section 05 FUEL SYSTEM Sub-section 02CARBURETOR) 22,30, Banjo Flitting, Plug Screw Whenever removing outlet banjo fittings
blocked NOTEGrease carburetor linkage at both ends with synthetic grease293 550 010) Whenever replacing the valve ensure
to install the right size Oetiker clamp on fittings The impulse line fitting uses 12 rnm (311164 in1 claimp293 650 044) Connect
linkage between both carburetors and fully tighten Allen screws on carburetor throttle rope lever MAG side CAUTIONThis set-up
is done ensure no backlaish between throttle rope llevers when throttle lever is pushed at handlebar grip, Throltle rope
lever MAG side The inlet and outlet line fittings use 13 mm (17132 in) clamp293 650 042) The vent fitting is blocked with