Bombardier SeaDoo 1990 factory shop manual, Page 91Get this manual

Bombardier SeaDoo 1990 factory shop manual, Page 91

Section 06 OIL SYSTEM Sub-section 01 (REPAIRADJUSTMENT) CHECKING OPERATION On Watercraft Bench Test The oil pump must be
level in small oil lines is passed banjo fitting by about 25 mrn (1 in) (this will be indicated by clerir section of small
oil lines of about 25 mrn (1 Ret eat the procedure untd this condition is attained Reconnect banjo fittings with washer on
each side, start eng ne and run at idleholding the pump lever in open position Oil columns must advance into small oil 'ines
Counterclockwise Oil must drip here FOOl 006 002 Ifremove puma assembly and check the pump gear and drive shaft (if applicable)
for defects, replace as necessary Test pump as describes below NOTEThrough normal use, oil level must not drop in small tubes