Bombardier SeaDoo 1990 factory shop manual, Page 102Get this manual

Bombardier SeaDoo 1990 factory shop manual, Page 102

Sectian 07 ELECTFUCAL Sub-section 03 (ELECTRIC STARTER) REMOVAL Urlfasten electrical box from hull 1f2f3fCirclip, Pinion
in cleaning salventDscard 0-rlings and gasket all Clean brushes and holdersclean cloth soaked in solvent Brushes must be
dried ihoroughly with clean Blow brush holders clean usng compressed alr RSupporT nuts then "rhrough bolts Separate starter
end trarne from yoke Wthdrawyoke from armature Bruh holder can be removed from end frame by un- WARNINGAlways wear safety
glasses when using cmpressed air sc?ebn retaningnut terminal Cha-k that the radal between the armature shaft play and end
frame IS not greater than 20 mm 00 In) Rep end frarne lf SCI Remove dirt, 011 or grease from commutator using clean cloth
soaked in suitable solvent Dry well using clean, dry clothClean engllne starter gear teeth and drive unit tclutch) NOTEBushrngs
must not be cleanedgrease dissolving algents Dry lmmerse metal components in cleaning solutonall dean, dry cloth Page: 102