Bombardier SeaDoo 1990 factory shop manual, Page 103Get this manual

Bombardier SeaDoo 1990 factory shop manual, Page 103

Section 07 ELECTRICAL Sub-Section 03 (ELECTRIC STARTER) Brush Holder Arrnature NOTEAn ohmmeter may be used for the following
no copper dust remains between segments after undercutting operation is completed Commutator undercut 0.20 mrn 1.008 in)
NOTENew brush lenglth is 12 mm472 in! Overrunning Clutch Check commutator of round condition with V-shaped out blocks and
an indicatorIf commutator out of round is more than 0.40 rnm 1.016 in), commutator should be turned on lathe Check commutator
outer diameterIf less than 30.7 mm (1 209 in), replacePinion of overrunning clutch should turn smoothly in cloclkwise direction,
and shoulld not slip in counterclockwise directionIf defective, repllace Check pinion teeth for wear and damage If defective,
replace Starter Switch Switch condition can be checked with an olhmmeter Install test probes on RED and YELLOW RED wires