Bombardier SeaDoo 1990 factory shop manual, Page 108Get this manual

Bombardier SeaDoo 1990 factory shop manual, Page 108

Section 07 ELECTRICAL Sub-section 04 (MAGNETO SYSTEM) - Install new receptacle connector to the blackyellow striped wire-
To install the new coil on the armature plate, remove the shipping nuts from the new coil and apply Loctite 242 (blue, medium
strength) to screws before assembly nectors- Use magneto coil centering tool (PIN 290 876 922) and install so that it fits
around armature plate before tightening screws Solider the yellow wire in the harness to the white tube protected wire of
the coil to the black tube protected wire of the coil - Solder the yellow4black striped wire in the harness White protector
with yellow wire of harness Black protector with yellowblack wire of harness Magneto coil centering tool290 876 922) 41,