Bombardier SeaDoo 1990 factory shop manual, Page 121Get this manual

Bombardier SeaDoo 1990 factory shop manual, Page 121

Section 07 ELECTRICAL Sub-section 05 (CDICHARGING SYSTEMS) - NIPPONDENSO IGNITION TESTER NIPPONDENSO IGNITION TESTER CDI
mentioned one anld ensure that the tester is installed on plane surface, away from vehicle vibrations TEST CONIDITION Generating
Coil Test (HI and LO) This test is performed on the vehicle at cranking speed The two generatingcoils are called high and
low speed generating coils The tester indicates the output of these coils by switchnng HI and LO positions as follows CONINECTION
OF TEST WIRE HARNESS HI Output of high speed generating coil LO Output of high and low speed generating coil Analysis of
this test is diagnosed by the number of LEDs in the indicator NOTEfew terms found on the function selllector of the Nippondenso
CDI tester are different from the ones used in this sectionControl unit and control unit diode will be described as ignition
module and ignition modulediode respectively, generator coil will be generating coil All CDI systems are desiginated as 4-5P