Bombardier SeaDoo 1990 factory shop manual, Page 122Get this manual

Bombardier SeaDoo 1990 factory shop manual, Page 122

Sub-section 5 Section 07 ELECTRICAL (CDISYSTEMS) IIGNITIONTYPE ENGINE TYPE TEST WIRE HARNESS Vehicle Wiring a) Connect the
coil a) Turn the power switch on Then one LED or two LEDs will light to indicate the tester IS operating Reset the indication
circuit by depressing the reset switch One LED will remain to indicate the checker is operating c) Securely connlect the
connectors of test wire harness "B" according to the following figures NOTE :After every test when the LED level indlicator
holds its indication few minutes, reset the by indication depressing the reset switch CAUTION :When connecting,be sure that