Bombardier SeaDoo 1990 factory shop manual, Page 123Get this manual

Bombardier SeaDoo 1990 factory shop manual, Page 123

ELECTRICAL Sub-section 05 (CDICHARGING SYSTEMS) Section 07 dl If the test results are over or lower than the limit, see 'Analysis
brown ground wire has been connected bl Disconnect the checker test wire harness from the gnition module output side el Set
the selector to CONTROL UNIT position Test wire harness f) Remove the protection cap from the end of hightension wire Protection
cap Disconnect Ignition rnoduie c) connect the IgnltIon coil connector the igmtion module connector, g) Keep distance of