Bombardier SeaDoo 1990 factory shop manual, Page 135Get this manual

Bombardier SeaDoo 1990 factory shop manual, Page 135

Section 08 PROPULSIONDRIVE SYSTEMS Sub-Section 01 (PROPULSIONDRIVE SYSTEMS) - - Weld one spacer 13 mrn (112 in1 thick 25
of nylon bushngs can be sliqhtly enlarged with 13 mm (112 in) round file (rait tail type1 Remove two retaining screws and
withdraw nozzle Push sleeves and bushings out of nozzle 17,20,35, Venturi, Screw0-Ring Remove four retaining screws and withdraw
ventun 6,7, NutImpeller Housilng Impeller housing can be easily separated from the hull with following suggested tool - Use
two steel angle bars 25 25 rnm (1 118 Nluts removed in) thick 400 mm (16 in) long - Drill two 10 mrn (318 in) diaholes in
each bar as shown in the following drawing Using screws previously removed from venturi, insert them in angle bar holes,