Bombardier SeaDoo 1990 factory shop manual, Page 136Get this manual

Bombardier SeaDoo 1990 factory shop manual, Page 136

Section 08 PROPULSIONDRIVE SYSTEMS Sub-section 01 (PROPULSIONDRIVE SYSTEMS) NOTEAn impact screwdriver can be used to loosen
two steel angle bars 25 25 mm (1 118 in) thick 225 mrn (9in) longbetween ride shoe and hull Use 25 mm (1 in) square tube
by approximately 125 rnm (5 in) long so that, with all parts welded, its overall length will not exceed 190 mrn (7-12 in)
- kind of turnbuckle is needed to apply extension force - On one end, weld 10 mm W8 in) dianut- Weld the head of 10 100 (318
in1 screw on top of one angle bar then screw in square tube - Insert 10 15 37,38,39,40,41, Shoe, ScrewGrate Ride NOTEGrate
must be removed pnor to removing ride shoe Impeller housing must be removed to allow ride shoe removal mm 8x 112 ml screw
through large and thick washer or suitable sleeveInstall nut on screw Do not fully tighten, ensure screw can easily rotate