Bombardier SeaDoo 1990 factory shop manual, Page 138Get this manual

Bombardier SeaDoo 1990 factory shop manual, Page 138

Section 08 PROPIULSIONDRIVE SYSTEMS Sub-section 01 (PROPULSIONDRIVE SYSTIEMS) 2,15, Fitting Fittings can be removed with
remover (P295 000 001) (1-2964 in) 14 rnrn (9116 in) Impeller shaft holder295 000 0821 Roll pin 40 1332 l F001 008 099 13,14,
Housing CoverScrew Starting with pump assembly move three retainmg screwsi n horizontal position, reCAUTIONNever use any
impact wrench to loosen impellerTo remove impeller, apply rotation movement and pull at same time Slide impeller out of housing
remove and tool Remove two screws holding impeller housing to shaft holderLift impeller housing away from impeller shlaft
Slide thrust washer and thrust bearing off shaft Place container under cover to catch oilUsing fiber hammer, gently tap cover
to release from impeller housing Insert impeller shaft holder295 000 0821 on flat end of impeller shaft Using two screws