Bombardier SeaDoo 1990 factory shop manual, Page 139Get this manual

Bombardier SeaDoo 1990 factory shop manual, Page 139

Section 08 PROPULSIONDRIVE SYSTEMS Sub-section 01 (PROPULSIONDRIVE SYSTEMS) 28, Wear Ri'ng Place impeller housing in brass
is not recommended push seal out with punchHousing andor bearingb) could be daimagedSeal should be removed using the following
suggested tool Seal puller, Snap-On #S6129IF001 009 031 Housing slot Pulling seal out of hlousing After cutting ring, insert
screwdriver blade under slit and raise ends of nng Slideout NOTEIf beanngs and seal need to be renewed, the special pusher
described in bearilng removal ( the following item), be used push Lhe lhiee o at same time Simply insert pusher from the