Bombardier SeaDoo 1990 factory shop manual, Page 140Get this manual

Bombardier SeaDoo 1990 factory shop manual, Page 140

Section 08 PROPULSIONDRIVE SYSTEMS Sub-section 01 (PROPULSIONDRIVE SYSTEMS) Or, use Snap-On Hammer Puller including Handle
then push tool using arbor press until bearings are out This remover tool may also be used with hammer However, care should
be taken not to damage bearing journalsout of housing F0Cn 009 036 NOTEIf seal is to be renewed at same time, ply insert
pusher from the side oplposite of seal then push seal and bearings out 4, Needle bearing 49,50,51,52, Seal, Seal CarrierNeedle
Bearing Seals and bearing can be removed us1ing same suggested tools as for pump unit Properly support seal carrier when
removing seals and bearing NOTEIt is always recommended to renew both bearings, even if only one needs to be replaced with