Bombardier SeaDoo 1990 factory shop manual, Page 141Get this manual

Bombardier SeaDoo 1990 factory shop manual, Page 141

Section 08 PROPULSIONDRIVE SYSTEMS Sub-section 01 (PROPULSIONDRIVE ) - CLEANING NOTEBailer tube fittings and cooling supply
for deformation or other damage Ensure they are firmly retained Inspect needle bearing of seal carrier and its contact surface
Check for scoring, pitting, chipping or other evidence of wear With finger tip, feel contact surfaces of bearing and seals
If any irregular surface is found, renew drive shaft Needle bearing contact surface Splines condition Seal contact surface
F001 040 Deflection Excessive deflection could damage splines of drive shaft, impeller, flywheel or seal carrier Install
drive shaft in V-Blocks and set dial gauge in center of shaft Slowly rotate shaftdifference between highest and lowest dial
gauge reading is deflection Refer to the following illustration Oil passages FOG1 039 Maximum permissible deflection is rnm020
in1 INSPECTION 26,43,51i,54, Impeller, Fliywheel, BeairingDrive Shaft Visually inspect splines of drive shaft, impeller and