Bombardier SeaDoo 1990 factory shop manual, Page 143Get this manual

Bombardier SeaDoo 1990 factory shop manual, Page 143

Section 08 PROPULSIONDRIVE SYSTEMS Sub-section 01 (PROPULSIONDRIVE SYSTEMS) T check both bearings, proceed the same way with
Measuring shaft diameters will determine defective part Using micrometer, measure diameters on bearing contact surfaces Minimum
shaft diameter should be 22 23 rnm8753 in) shaft within tolerance indicates worn bearingsReplace both bearings FOOOI 009
080 Measure thrustbeanna thicknessIf roller diameter is mrn i.076 in), renew it found smaller thlan Measuring shaft diameter
at bearing contact surface Measulring thrust bearing thickness NOTEWhen replacing either washer or bearing, recommended to