Bombardier SeaDoo 1990 factory shop manual, Page 146Get this manual

Bombardier SeaDoo 1990 factory shop manual, Page 146

Sectktn 08 PROPULSIONDRIVE SYSTEMS- Sub-Section 01 (PROPULSIIONDRIVE SYSTEMS) 5ear1ng1 nmpeller side must be1 to mm 060 onI00
rnpeller) Apply Loctnte 515 (PIN 293 800 0071 lln seal housng, all around Duter dameterand on seal seat Properly msert seal
on tool L 515 all around and behind Rased edge of seal s 7,8#9,10,26, Impeller Housingr Thrlust Washer, Thru,st Bearing#
mpeller Shaftlmpeler Rased edge of seal here Ilnsert flat edges of impeller shaft ln vise so that shaft is vertical Apply
synthetcgrease293 550both sides of thrust bearing then nsert onto shaft followed1 by thrust washer Properly center washer
and bearngshaft from slding lnstallaat flange Grease WIII prevent parls wedging thrust bearng inlo shaft tion and thus possbly