Bombardier SeaDoo 1990 factory shop manual, Page 147Get this manual

Bombardier SeaDoo 1990 factory shop manual, Page 147

Section 08 PROPULSIONDRIVE SYSTEMS Sulb-Section101 [PROPIULSIONDRIVE ) - Remove special tool brush and clean impeller shaft
prevent seal 11p damage when lnsertlng impeller shaft, use rnpeller shaff guide 295 000 002) Apply Loctite 271 Fool 009 060
Insert tool onto shaft then carefully slide housng end over housng onto shaft CAUTIONMake sure thrust washer and bearing
have not slipped in shaft grooveUsing two screws previously removed from ventulrl, secure mpeller shaft holder295 000 082)
housto lng Install shaft holder in To ease mpellernstallat+on, apply 11qu1d soap on1 wear Insert mpeller wear ring Manually
rotate impeller and push so that it slides on impeller threads Carefully engagle threads makng sure they are well altgned
Install mpelter remover 295 000 001) ,into mpeller sphnes and tighten CAUTIONMake sure thrust washer and bearing are not