Bombardier SeaDoo 1990 factory shop manual, Page 149Get this manual

Bombardier SeaDoo 1990 factory shop manual, Page 149

Section 08 PROPULSIONDRIVE SYSTEMS Sub-section 01 (PROPULSIONDRIVE SYSTEMS) - CAUTION :This is synthetic oilDo not mix with
Locate 242 (blue) 293 800 015) on threads and install screws and washers then torque to 25 (18 lbfft) in criss-cross sequence
Clean drive shaft splines with Loctite solvent 755IV 293 800 0191 Free splines from any residue Allow solvent to dry thoroughly
Generously apply synthetic grease 293 550 0101 on drive shaft splines and impeller splinesMake sure rubber damper is on drive
shaft end Insert drive shaft in impeller then carefully insert boot in impeller Use blade of screwdriver to push on boot
Then push 0-Ring under the boot as far as possiblle using screwdriver blade Bailer massages aligned Loctite 242 (bluel Loctite
515 on mating surfaces NOTEOn aluminum material it is recommended to use Loctite Primer 293 600 012) to reduce curing time